|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent service manual includes everything is need to repair this radio-caseete, how to disassemble, wiring diagram, all , waiting time until the download was only a few hours. I'm going to buy service manuals from here, are cheap and very good.Thank you.
;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
ADJUSTMENT INSTRUCTION
1. Application Object
This instruction is for the application to the LCD TV/Monitor, ML-024E. (8) At this time the adjustment starts automatically changing the number in order of RO --> GO --> BO --> RD --> GD -> BD. Finally, when the number of BD is changed the adjustment is completed. (9) Press the MENU or EXIT key to come out of the adjustment mode.
2. Notes
(1) This LCD TV has power within set. Connect the power correctly, then start the adjustment. (2) The adjustment must be performed under the correct sequence. (3) The adjustment must be performed in the circumstance of 25±5°C of temperature and 65±10°C of relative humidity if there is no specific designation. (4) The input voltage of the receiver must keep 100~220V, 50/60Hz in adjusting. (5) The set must be operated for 15 minutes preliminary before adjustment if there is no specific designation. �Heat Run� must be performed with the full white signal or TV noise signal in the internal part of the set. O The time for �Heat Run� can be changed owing to production plan. O Condition of Line Test : Standard color signal - 65±1dBuV
O
3. PC Mode Adjustment
3-1. Required Test Equipment
(1) Window Pattern which satisfied with VESA Spec. or pattern which has White-Black signal simultaneously. (2) Remote control for adjustment
3-2. Preparation for Adjustment
(1) Perform �Heat Run� for more than 15 minutes in white pattern. (2) Connect the signal of pattern generator with LCD TV of PC Input Jack(D-Sub). (3) Confirm the XGA(1024x768) Window Pattern or signal(White-Black) using the 801-GF/GD, VG819. (4) Use the IN-START Key on R/C for adjustment to enter the PC adjustment mode. (5) Example of adjustment screen.
<Fig. 1> (6) Enter into the adjustment mode as <Fig. 1> and select the cursor(red letters) to �RGBSE � with the channel key on R/C for adjustment. (7) Press the Volume on R/C for adjustment.
|
|
|
> |
|
